|
FUNCTIONS
|
Functions listed below with "#"
marks are available when the Link Display VSD CONCEPT is connected to
Link Control Unit II (or Link Control Unit) and sensors are connected.
|
 Digital and bar
display |
|
Following information is displayed in Digital and bar display.
|
Display contents
|
Digital display
|
Bar display
|
| Speed |
|
|
| Engine speed |
|
|
| Oil pressure # |
|
|
| Fuel pressure # |
|
|
| Oil temperature # |
|
|
| Water temperature # |
|
|
| Exhaust temperature # |
|
|
 AVAILABLE
|
 NOT AVAILABLE
|
 Data on turbo or boost cannot be displayed.
|
| Warning display
(LED and digital display) # |
Warning values can be set discretionary. Double warning of
engine speed is also settable by equipping two LED indicators.
|
| Record and Replay
# |
Connected sensor data and speed data can be recorded for a
maximum of 3 minutes. The data can be replayed later.
|
| Auto Warning
# |
When a non-displayed value exceeds the set value, the
display changes from selected data to the current warning value
automatically.
|
| Opening/Ending
display |
Opening and ending modes are performed after the ignition
key is turned on and off.
|
| Automatic
illumination control |
|
The brightness is adjusted automatically.
Auto dimmer mode and manual dimmer mode are available. When the auto
dimmer mode is selected, the brightness of display is adjusted
automatically depending on the outside light. The brightness can be
selected from 3stages.
When the manual dimmer mode is selected, the brightness of display is
fixed. The brightness can be selected from 5 stages.
|
| Special
display |
When the vehicle's speed is 0 MPH/0 km/h continues for
more than 10 seconds, engine speed is displayed digitally.
|
| Warm-up display
(oil temperature or water temperature) # |
Oil temperature or water temperature is displayed until
the temperature reaches the set value.
|
| Control out
# |
Signals of oil temperature or water temperature can be
output when it reaches the set value. It's possible to operate a warning
lamp or a motor when a temperature reaches the set value.
|
| Peak display
# |
Maximum values which sensors are connected are displayed.
If speed is recorded, the minimum value can be displayed.
|
| LINK connectors
for Link Meter # |
D.C. Unit (exclusive unit for Link Display VSD CONCEPT)
has 3 LINK connectors for Link Meters.
|
| EXAMPLES OF
DISPLAYS |
| When
the Link Display VSD CONCEPT is used WITHOUT the Link System |
Speed/Engine speed
|
Peak display
|
Special display
|
|
| When
the Link Display VSD CONCEPT is connected to the Link System |
Water temperature # /
Engine speed
|
Oil temperature # /
Engine speed
|
Oil pressure # /
Engine speed
|
Exhaust temperature # /
Engine speed
|
Fuel pressure # /
Engine speed
|
Speed/Oil pressure #
|
Speed/Fuel pressure #
|
Auto warning
|
Tacho warning
|
|
